By connecting a molding machine and an take-out machine with 8-bit binary output, the conditions of the take-out machine can be saved in the molding machine, and when molding conditions are called, the conditions of the take-out machine can also be called at the same time. This not only shortens the time required for recalling conditions, but also prevents errors.
Mold damage or chuck plate damage due to forgotten or incorrectly set take-out conditions
When molding conditions are changed, take-out machine operating conditions can be automatically changed.
By eliminating "pokamis" such as forgetting to set take-out conditions or making a mistake, repair costs for mold damage and chuck plate damage can be reduced.
Basis of Effect Amount Calculation
Connect the molding machine (terminal block in the control panel) to the take-out machine using a cable compatible with 8-bit binary output. Setup and monitoring can be performed using the "Linking conditions of take-out machine" section of the "System setup screen" (standard equipment).
Mode used/not used
■Condition No.1 to 256 (Maximum number of conditions: 256)
Prepared state of the take-out machine
■Condition transfer status
SE-EV-S / SE-EV-S-HD / SE-EV-A / SE-EV-A-HD / SE-EV